Figure 12-2 Static Group Configuration - Zte ZXR10 5900E Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv6)

Figure 12-2 Static Group Configuration

Configuration Thought
1. Configure addresses on the interfaces of the routers in interface configuration mode.
2. Enable multicast function by configuring ipv6 multicast-routing.
3. Enter PIM route mode and then enter the interfaces.
4. Enable PIM-SM in interface configuration mode.
5. Enter MLD route mode from multicast mode and then enter the interfaces.
6. Configure static group join on vlan1 of S1.
7. Send MLD group join messages to S1 on the PC.
Configuration Commands
S1 configuration:
S1(config)#interface vlan1
S1(config-if-vlan1)#ipv6 enable
S1(config-if-vlan1)#ipv6 address 100::1/64
S1(config-if-vlan1)#exit
S1(config)#ipv6 multicast-routing
S1(config-mcast-ipv6)#router pim
S1(config-mcast-ipv6-pim)#interface vlan1
S1(config-mcast-ipv6-pim-if-vlan1)#pimsm
S1(config-mcast-ipv6-pim-if-vlan1)#end
S1#configure terminal
S1(config)#ipv6 multicast-routing
S1(config-mcast-ipv6)#router mld
S1(config-mcast-ipv6-mld)#interface vlan1
S1(config-mcast-ipv6-mld-if-vlan1)#static-group ffee::1 source 200::1
S1(config-mcas-ipv6-mld-if-vlan1)#end
Configuration Verification
View interface information on S1:
S1#show ipv6 mld interface vlan1
vlan1
Internet address is 100::1
MLD is enabled on interface
Current MLD version is 2
MLD query interval is 125 seconds
MLD last member query interval is 1 seconds
MLD query max response time is 10 seconds
SJ-20150114102049-011|2015-01-15 (R1.0)
12-10
ZTE Proprietary and Confidential