Figure 13-1 Pim-Sm Configuration Example - Zte ZXR10 5900E Configuration Manual

Chapter 13 IPv6 PIM-SM Configuration

Figure 13-1 PIM-SM Configuration Example

Method
1. Configure related interfaces.
2. Enter multicast configuration mode.
3. Enter PIM-SM configuration mode.
4. Set the loopback5 interface on S2 to CRP and BSR.
5. Enable PIM-SM on interfaces.
6. Configure a unicast route to the RP on S1. Configure a unicast route to the multicast
source on S2 (In this example, static route or IGP can be used).
Steps
S1 configuration:
S1(config)#ipv6 multicast-routing
S1(config-mcast-ipv6-pim)#router pim
S1(config-mcast-ipv6-pim)#interface vlan1
S1(config-mcast-ipv6-pim-if-vlan1)#pimsm
S1(config-mcast-ipv6-pim-if-vlan1)#exit
S1(config-mcast-ipv6-pim)#interface vlan2
S1(config-mcast-ipv6-pim-if-vlan2)#pimsm
S1(config-mcast-ipv6-pim-if-vlan2)#dr-priority 20
S1(config)#ipv6 route 100::1/128 199::2
S2 configuration:
S2(config)#ipv6 multicast-routing
S2(config-mcast-ipv6)#router pim
S2(config-mcast-ipv6-pim)#rp-candidate loopback5
S2(config-mcast-ipv6-pim)#bsr-candidate loopback5
S2(config-mcast-ipv6-pim)#interface vlan3
S2(config-mcast-ipv6-pim-if-vlan3)#pimsm
S2(config-mcast-ipv6-pim-if-vlan3)#exit
S2(config-mcast-ipv6-pim)#interface vlan2
S2(config-mcast-ipv6-pim-if-vlan2)#pimsm
S2(config-mcast-ipv6-pim-if-vlan2)#dr-priority 20
13-17
SJ-20150114102049-011|2015-01-15 (R1.0) ZTE Proprietary and Confidential