Ospfv3 Maintenance And Diagnosis - Zte ZXR10 5900E Configuration Manual

Parameter
<type>
route-map <map-name>
The command parameter in step 13 is described as follows:
Parameter
<X:X::X:X/128>
The command parameters in step 14 are described as follows:
Parameter
<delay>
<holdtime>

7.3 OSPFv3 Maintenance and Diagnosis

Compared with RIPng, OSPFv3 is more complicated. There are many fault reasons behind
a fault symptom. Therefore, the maintenance and diagnosis of OSPFv3 is more difficult.
To maintain and diagnose OSPFv3, use the following commands.
Command
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
The following example shows the outputs of the command show ipv6 ospf:
ZXR10#show ipv6 ospf
Routing Process "ospfv3 1" with ID 1.1.1.8
SPF schedule delay 5 secs. Hold time between two SPFs 10 secs
Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
SJ-20150114102049-011|2015-01-15 (R1.0)
Description
Specifies the metric-type of the redistributed LSA. The value
is 1-2. The default value is 2.
Specifies the route map used for protocol route redistribution.
Description
Prefix and prefix length of the IPv6 routes summarized.
Description
Specifies the delay of route re-computation that follows after
route updates are received in the unit of seconds. The value
range is 0-65535. The default value is 5 seconds.
Specifies the hold time in the unit of seconds. The value
range is 0-65535. The default value is 10 seconds.
show ipv6 ospf <process id>
show ipv6 ospf database
show ipv6 ospf interface [<interface-name>]
show ipv6 ospf neighbor
show ipv6 ospf virtual-links
7-11
Chapter 7 OSPFv3 Configuration
Function
Shows an OSPFv3 instance.
Shows the database information
about an OSPFv3 instance.
Shows the interface information
about an OSPFv3 instance.
Shows the neighbor information
about an OSPFv3 instance.
Shows the virtual link information
about an OSPFv3 instance.
ZTE Proprietary and Confidential