Command Output
Interface
2.4 NDP Configuration Example
General Description
This example describes how to configure static entries in the NDP neighbor cache table
of the interface VLAN10 on a switch.
Method
1. Enter the interface configuration mode, and add a static entry to the neighbor cache
table.
2. Show the content of the neighbor cache table, and check whether the static entry has
been successfully added.
Steps
Router configuration:
ZXR10(config)#interface vlan10
ZXR10(config-if-vlan10)#nd6 add 780::1 0000.0a00.1345
Verification
Verify the configuration results on the router:
ZXR10#show nd6 cache
Total Cache Number Is:1
Only Current Valid Items Are Shown Below:
Address
780::1
The above results indicate that a static entry has been successfully added to the NDP
neighbor cache table.
SJ-20150114102049-011|2015-01-15 (R1.0)
link-Address
age
0000.0a00.1345
static
Description
Probe: The neighbor reachability is indeterminate. A probe
message is sent to verify the reachability.
Indicates the interface name of the entry.
status
Interface
Reachable
vlan10
2-7
ZTE Proprietary and Confidential
Chapter 2 NDP Configuration