Ripng Maintenance And Diagnosis - Zte ZXR10 5900E Configuration Manual

Parameter
[only]

6.3 RIPng Maintenance and Diagnosis

To maintain and diagnose RIPng, use the following commands.
Command
ZXR10(config)#
ZXR10(config)#
>|<X:X::X:X>}][vrf <vrf-name>]
ZXR10(config)#
ace-name>
The command parameters are described as follows:
Parameter
vrf <vrf-name>
X:X::X:X
X:X::X:X/<0-128>
<interface-name>
The following example shows the outputs of the command show ipv6 rip:
ZXR10(config)#show ipv6 rip
RIPng protocol, port 521, multicast-group FF02::9
administrative distance is 120
default metric is 1
updates every 30 seconds, expire after 180 seconds
garbage collect after 120 seconds
the number of ripng routes:
connect ripng route 0
aggregate ripng route 0
ripng route 0
Redistribution:
The outputs of the command show ipv6 rip are described as follows:
Command Output
port 521
SJ-20150114102049-011|2015-01-15 (R1.0)
show ipv6 rip [vrf <vrf-name>]
show ipv6 rip database [{X:X::X:X/<0-128
show ipv6 rip interface [vrf <vrf-name>]<interf
Description
VRF name, with 1-32 characters
Indicates the specific IPv6 route prefix.
Indicates the IPv6 route prefix and prefix length.
Indicates the interface name.
Description
Indicates that the RIPng uses UDP port 521.
6-7
Chapter 6 RIPng Configuration
Description
Indicates that only the default route will be sent on the
interface.
Function
Shows the content of the RIPng
protocol.
Shows the RIP route database
information.
Shows the interfaces on which
RIPng is enabled.
ZTE Proprietary and Confidential