Configuring Ipv6 Static Multicast - Zte ZXR10 5900E Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv6)
l If the longest matching rule is used, the longest matching path is selected from the
three paths.
l
If the three paths have the same subnet mask, the highest-priority path is selected.
l
If the three paths have the same priority, the path is selected in the following order:
Static multicast path
à
MGGP path
à
Unicast path
à
This optimal path is used as an RPF route.
corresponding RPF interfaces and RPF neighbors are also determined.

15.2 Configuring IPv6 Static Multicast

To configure IPv6 static multicast routing, perform the following steps:
Step
1
2
3
4
For a description of the parameters in Step 2, refer to the following table:
Parameter
<xg-limit>
<sg-limit>
For a description of the parameters in Step 3, refer to the following table:
Parameter
<group-address>
<source-address>
SJ-20150114102049-011|2015-01-15 (R1.0)
Command
ZXR10(config-mcast-ipv6)#
multicast-static-start
ZXR10(config-mcast-ipv6)#
multicast-static-limit xg <xg-limit> sg
<sg-limit>
ZXR10(config-mcast-ipv6)#
multicast-static-route <source-address><grou
p-address>[{[iif <iif-name>],[oif <oif-index>]}]
ZXR10(config-mcast-ipv6)#
multicast-static-interface index <index>
interface <interface-name>
After an RPF route is determined,
Function
Enables the MSTATIC protocol.
ipv6
Configures the maximum number of static
ipv6
multicast routes.
Configures a static multicast routing entry.
ipv6
Configures a static multicast egress
ipv6
interface set.
Description
Maximum number of static multicast routes (*,
G), default: 0.
Maximum number of static multicast routes (S,
G), default: 0.
Description
Multicast group address.
Multicast source address.
15-2
ZTE Proprietary and Confidential