Ospfv3 Configuration Example 2 - Zte ZXR10 5900E Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv6)

7.4.2 OSPFv3 Configuration Example 2

Configuration Description
As shown in
interfaces, S1 and S2 establish the link in area 0 whereas S2 and S3 establish a link
with each other in area 10 to advertise their respective loopback address route, and S1
redistributes the direct route.
Figure 7-2 OSPFv3 Configuration Example 2
Configuration Thought
1. Enable the IPv6 protocol on the interfaces, configure IPv6 addresses for these
interfaces, configure loopback interfaces, enable IPv6 on the loopback interfaces,
and configure IPv6 addresses for the loopback interfaces.
2. Configure OSPFv3.
3. Add the interfaces to OSPFv3. S1 and S2 establish a link with each other in area 0,
S2 and S3 establish a link with each other in area 10, and S1 redistributes the direct
route.
4. Check and verify the configuration results: Neighbors are correctly established
between the routers, each router can learn the routes advertised by the other two
routers, and each router can ping the loopback interfaces of the other two routers.
Configuration Commands
S1 configuration:
S1(config)#interface vlan10
S1(config-if-vlan10)#ipv6 enable
S1(config-if-vlan10)#ipv6 address 3611::11/64
S1(config-if-vlan10)#exit
S1(config)#interface loopback5
S1(config-if-loopback5)#ipv6 enable
S1(config-if-loopback5)#ipv6 address 3555::52/64
SJ-20150114102049-011|2015-01-15 (R1.0)
Figure 7-2, S1 and S2 establish a link with each other via the direct connection
7-16
ZTE Proprietary and Confidential