Ripng Configuration Example; Figure 6-1 Ripng Configuration Example - Zte ZXR10 5900E Configuration Manual

Command Output
vlan10: interface is up
RIPng is enabled
Split horizon enabled
Poison reverse enable
IPv6 interface address:
2010::13/64

6.4 RIPng Configuration Example

General Description
As shown in
of the two routers. Here, a loopback address is taken as an example and can redistribute
other routes. The redistribution of direct routes is taken as an example.

Figure 6-1 RIPng Configuration Example

Method
1. Enable the IPv6 protocol on the interfaces and configure IPv6 addresses.
2. Configure the RIPng protocol.
3. Enable the RIPng-related configurations on the interfaces.
4. Configure the redistribution commands if it is necessary to redistribute other routes.
5. Check the configuration results, and confirm that neighbors are correctly established
between the two routers and each router can learn the routes advertised by the peer
router.
Steps
S1 configuration:
S1(config)#interface vlan1
S1(config-if)#ipv6 enable
S1(config-if)#ipv6 address
S1(config-if)#exit
SJ-20150114102049-011|2015-01-15 (R1.0)
Figure 6-1, the RIPng runs on routers S1 and S2 to advertise the RIPng routes
3611::11/64
Description
Indicates that the vlan10 is up.
Indicates that PIPng is enabled on the interface vlan10.
Indicates that the split horizon is enabled.
Indicates that the poison reverse is enabled.
Indicates that the address of the interface vlan10 is
2010::13/64.
6-9
ZTE Proprietary and Confidential
Chapter 6 RIPng Configuration