Cisco ASA 5505 Configuration Manual page 1755

Appendix B Configuring an External Server for Authorization and Authentication
Associate the LDAP attribute map to the AAA server.
Step 3
The following example enters the aaa server host configuration mode for the host 3.3.3.4, in the AAA
server group MS_LDAP, and associates the attribute map static_address that you created in step 2:
hostname(config)# aaa-server MS_LDAP host 3.3.3.4
hostname(config-aaa-server-host)# ldap-attribute-map static_address
Verify the vpn-address-assigment command is configured to specify aaa by viewing this part of the
Step 4
configuration with the show run all vpn-addr-assign command:
vpn-addr-assign aaa
hostname(config)# show run all vpn-addr-assign
vpn-addr-assign aaa
no vpn-addr-assign dhcp
vpn-addr-assign local
hostname(config)#
Establish a connection to the adaptive security appliance with the AnyConnect client. Observe the
Step 5
following:
• The banner is received in the same sequence as a clientless connection
The user receives the IP address configured on the server and mapped to the adaptive security
•
appliance
Figure B-7
OL-20339-01
<<<< ensure this configured.
(Figure B-8).
Verify the Banner for the AnyConnect Session
Configuring an External LDAP Server
Cisco ASA 5500 Series Configuration Guide using ASDM
(Figure B-7).
B-23