Smdac1Standby - PEP Modular Computers Modular Computers RS485 User Manual

Chapter 5 Analog Modules

5.5.8.5 SMDAC1StandBy

Syntax
error_code SMDAC1StandBy(u_int8 PortNr);
Description
This function places the module connected on Port PortNr in standby mode
where the outputs are disconnected from the screw terminal block.
Input
u_int8 PortNr
Output
error_code
Example
RetVal = SMDAC1StandBy(0);
October 01, 1996
SM-Port number to be accessed
SUCCESS
E_SEEK
E-BMODE
or standard OS-9 error code (refer to the OS-9
Technical Manual Error Codes Section).
©1996 PEP Modular Computers GmbH
SMART I/O User's Manual
if module was not initialised
if the module is unknown
5
Page 5 - 117