Configuring Communication Settings
FIG. 46
NetLinx Studio - Device Addressing dialog
2.
Press the Master IP/URL button to open the on-screen keyboard, and enter the Master's IP address or
URL. This information can be obtained from the Networking Addresses dialog in NetLinx Studio:
a.
In NetLinx Studio, select Diagnostics > Network Addresses to open the Network Addresses dialog
(FIG. 47).
FIG. 47
NetLinx Studio - Network Addresses dialog
b.
Click Get IP Information to retrieve IP information from the NetLinx Master.
3.
Click Done to accept the new value and return to the System Configuration page.
4.
Press the Back button to open the Protected Setup page.
If the Master has been secured, a Username and Password are required.
5.
Reboot the TPI-PRO/DVI (see the Rebooting the TPI-PRO/DVI section on page 54).
48
If the TPI-PRO/DVI does not appear in the Online Tree in NetLinx Studio, make sure that the
NetLinx Master System Number, which can be derived from NetLinx Studio's Device Addressing
dialog (FIG. 46), is assigned correctly.
TPI-PRO/DVI (Total Presentation Interface)