AMX TPI-PRO-2 Operation/Reference Manual page 79

Protected Setup Page (Cont.)
System
Recovery:
Reboot Panel:
Keyboard
Layout:
Serial Port
Baud Rate:
TPI-PRO/DVI (Total Presentation Interface)
These options provide the ability to reset the TPI-PRO/DVI to factory default settings and/
or wipe out all existing touch panel pages:
• Reset System Settings - push to wipe out all current configuration parameters on the
TPI-PRO/DVI (including IP Addresses, Device Number assignments, Passwords, and all
Presets).
Pressing this button launches the Confirmation dialog which prompts you to confirm your
selection:
The Yes option is enabled after a 5-second delay (press Yes to proceed).
• Remove User Pages - press to remove all TPD4 touch panel pages currently loaded on
the TPI-PRO/DVI (including the pre-installed AMX Demo pages).
Pressing this button launches the Confirmation dialog which prompts you to confirm your
selection.
The Yes option is enabled after a 5-second delay (press Yes to proceed).
Press to reboot the TPI-PRO/DVI.
Note: A reboot is required to apply changes made in the Setup pages.
Use the UP/DN buttons to select the type of keyboard you want to use.
Use the UP/DN buttons to set the baud rate on the front Serial port.
• Range = 1200 - 115200
• Default = 115200
Protected Setup Page
73