AMX TPI-PRO-2 Operation/Reference Manual page 184

Using G4 Web Control®
This is not the IP address of the Master, but the IP address of the target touch panel.
You can find the IP address in the Wired Ethernet - System Connection > IP Settings
section.
9.
If you setup a WebControl password on the G4 WebControl page, a G4 Authentication dialog appears in
the secondary browser window (FIG. 97).
FIG. 97 G4 Authentication dialog
10.
Enter the Web Control session password into the Session password field (FIG. 95).
This password was previously entered into the Web Control Password field in the G4 Web Control page
on the TPI-PRO/DVI (see FIG. 93 on page 175).
11.
Click OK to send the password to the TPI-PRO/DVI and begin the session. A confirmation message
appears stating "Please wait, Initial screen loading..."



178
The secondary window becomes populated with the same G4 page being displayed on the target G4
panel.
A small circle appears within the on-screen G4 panel page and corresponds to the location of the
mouse cursor.
A left-mouse click on the computer-displayed panel page equates to an actual touch on the target
G4 panel page.
TPI-PRO/DVI (Total Presentation Interface)