AMX TPI-PRO-2 Operation/Reference Manual page 17

TPI-PRO Specifications (Cont.)
Front Panel Components (Cont.)
• Buttons:
Rear Panel Components
• VIDEO/VGA Inputs:
• VGA Outputs:
• Source TOUCH,
KEYBOARD/MOUSE
USB ports:
• Host USB Touch
Monitor KEYBOARD/
MOUSE USB ports:
• ETHERNET
10/100 port:
• TOUCH INPUT
port:
• AUDIO OUT
connector:
• Power connector:
TPI-PRO (Total Presentation Interface)
Four white buttons provide access to the following configuration options:
• RESOLUTION: Opens a screen used to select the TPI-PRO output video signal
resolution, ranging from 640 x 480@60Hz to 1920 x 1200@60Hz.
This output resolution setting must not be greater than the resolution on the
connected panel.
Refer to the Setting the Output Resolution section on page 34.
• TOUCH: Opens the Panel Information page, where you can select from a series of
serial touch panel drivers, and select the driver that corresponds to the serial
touch panel connected to the TPI-PRO (via the TOUCH INPUT connector).
Refer to the Setting the Touch Drivers (Serial Touch Monitors Only) section on
page 35 for more information.
• CALIBRATE: Opens the Calibration page, displaying a series of crosshairs. These
crosshairs are used to calibrate the touch device being used.
Refer to the Calibrating the TPI-PRO/DVI section on page 36.
• SETUP: Opens the TPI-PRO firmware setup menu.
Refer to the TPI-PRO/DVI Configuration Pages section on page 55.
HD-15 connectors, one per input source (1-4 on the TPI-PRO-4, 1-2 on the
TPI-PRO-2).
Each connector supports VGA graphics, S-video, composite video, and component
video.
2 HD-15 connectors:
• 1 connector for the touch-panel control display which displays the video feeds, G4
graphics, external windowed video/graphics inputs, and annotation graphics (G4
graphics can be turned off under program control).
• 1 connector for the public-view non-touch monitor which displays only the video
feeds, G4 graphics, external windowed video/graphics inputs, and annotation
graphics (G4 graphics can be turned off under program control).
• Both outputs use the same resolution settings.
Each output can send a maximum resolution of 1920 x 1200@60 Hz.
Note: The TPI-PRO does not provide Component (YPbPr) or Interlaced outputs.
2 or 4 USB Type-B device ports, one per source computer. For source USB Touch
Monitors, mouse/keyboard control (1-4 on the TPI-PRO-4, 1-2 on the TPI-PRO-2).
Note: Do not use a USB hub to connect multiple USB devices to the TPI-PRO.
2 USB Type-A ports that can be used for a keyboard, mouse, external storage unit,
or USB-capable touch panel interface.
Note: Do not use a USB hub to connect multiple USB devices to the TPI-PRO.
RJ-45 port provides 10/100 Mbps communication with the NetLinx Master (via ICSP
protocol over Ethernet).
• The Ethernet port automatically negotiates the connection speed (10 Mbps or 100
Mbps), and whether to use half duplex or full duplex mode.
• This communication is reflected via the front ICSP LED.
RS-232 (DB9) 9-pin serial port provides connectivity to a pointer device (i.e. touch
screen) that requires a serial connection.
3.5mm mini-jack provides stereo output - for use with line-level (0.707 VRMS) non-
amplified stereo output only.
2-pin 3.5 mm mini-Phoenix connector.
TPI-PRO (Total Presentation Interface)
3