AMX TPI-PRO-2 Operation/Reference Manual page 38

Total presentation interface
Hide thumbs Also See for TPI-PRO-2:
Table of Contents

Advertisement

System Installation


6.
Connect the touch monitor's video output connector to the VGA OUTPUT 1 port on the TPI-PRO.
7.
Apply power to the TPI-PRO.
8.
Code a button on the touch monitor page to enable the pass-thru feature on a selected input card slot.
Toggling this coded panel button can enable/disable the pass-thru feature.
You must set the TPI-PRO to match the resolution of the touch monitor's video output
resolution, then select a touch driver.
The video should automatically fill-in the available screen area on the touch monitor.
If the image generated from the TPI-PRO is slightly "off", adjust the image using the
monitor's on-board video adjustment buttons.
9.
Setup the TPI-PRO output resolution using the procedures in the Setting the Output Resolution section on
page 34.
If the TPI-PRO is turned off and then has power re-applied (power cycling), video
alignment settings established through the Video and/or RGB pages could be reset
unless the adjusted values have been previously saved.
Refer to the Setup - Video Settings Page section on page 64 for more information.
10.
Setup the touch drivers for the connected touch monitor by using the procedures in the Setting the Touch
Drivers (Serial Touch Monitors Only) section on page 35.
11.
If necessary, use the panel's video adjust buttons to align the incoming video signal to fit into the
available screen area. Initially positioning the incoming video can reduce the necessity of later
adjustments (H-position, V-position, H-size, etc.) through the RGB Setup page.
24
For touch monitors with Serial-touch connectors, use a DB9 Serial cable to connect the touch
monitor's touch input connector to the TOUCH INPUT (DB9) connector on the TPI-PRO. Refer to
the TOUCH INPUT (DB-9) Port section on page 15 for a description of the TOUCH INPUT
connector pinouts.
For touch monitors with USB-touch connectors, use a USB cable to connect the touch monitor's
touch input connector to the KEYBOARD/MOUSE (USB Type A) connector on the TPI-PRO.
TPI-PRO (Total Presentation Interface)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tpi-pro-4

Table of Contents