Using Takenote - AMX TPI-PRO-2 Operation/Reference Manual

Using Takenote™

Overview
The TakeNote application allows you to create on-screen annotations over the displayed video sources, using a
Pointing device (i.e. USB mouse or touch screen) connected to a TPI-PRO or TPI-PRO-DVI.



Enabling TakeNote on the TPI-PRO/DVI
The TakeNote feature of the TPI-PRO/DVI must be enabled before TakeNote can be used:
1.
Open the TakeNote Control page (FIG. 98):
Press to toggle
Enable / Enabled
FIG. 98
TakeNote Control page
a.
Press the front panel SETUP pushbutton to open the Setup page.
b.
Press Protected Setup to open the Protected Setup page. This page is password-protected:


c.
Press TakeNote to open the TakeNote Control page.
2.
Press Enable/Enabled until it toggles to Enabled (as shown in FIG. 98).
Starting a TakeNote Session
Once TakeNote has been Enabled, it is ready to use:
1.
Click Back in the Protected Setup page to return to the Setup Page.
2.
Click Exit in the Setup Page to close the Setup page.
3.
When TakeNote is enabled, the TakeNote icon is displayed in the upper-right corner of the display area
(FIG. 99):
TPI-PRO/DVI (Total Presentation Interface)
Refer to the Protected Setup - TakeNote Control Page section on page 85 for descriptions of all of
the options on the TakeNote Control page.
Verify your NetLinx Master has the latest firmware (*.KIT) file loaded.
Verify your NetLinx Master's IP Address and System Number have been properly entered into the
Master Connection section of the System Settings page (see the Configuring the Master Connection
Settings section on page 42).
Use the on-screen keypad to enter the default password - 1988.
Press Done to close the keypad.
Using Takenote™
179