AMX TPI-PRO-2 Operation/Reference Manual page 65

Setup Page (Cont.)
• Setup Page
Navigation
Buttons:
• Setup Page
Navigation
Buttons
(Cont.):
• Connection
Status:
• Display
Timeout:
• Inactivity Page
Flip Timeout:
TPI-PRO/DVI (Total Presentation Interface)
The navigation buttons displayed along the left of the Setup Page provide access to several
additional configuration pages:
• Protected Setup - Press to access the main Protected Setup Page.
Refer to the Protected Setup Page section on page 71.
• Information - Press to access the Project Information Page. This page displays various
properties of the TPDesign4 project file currently loaded on the TPI-PRO/DVI (read-only).
Refer to the Setup - Project Information Page section on page 61.
• Time - Press to access the Time & Date Settings Page. The options on this page allow you
to alter the time and date settings on the TPI-PRO/DVI.
Refer to the Setup - Time & Date Settings Page section on page 62.
• Audio - Press to access the Audio Settings Page. The options on this page allow you to
adjust various audio parameters.
Refer to the Setup - Audio Settings Page section on page 63.
• Video - Press to access the Video Settings Page. The options on this page allow you to
set the properties for incoming video signals.
Refer to the Setup - Video Settings Page section on page 64.
This read-only area indicates the TPI-PRO/DVI's connection status, the encryption status of
the NetLinx Master, the connection type, and the System to which this TPI-PRO/DVI is
connected.
Sets the length of time (in minutes) the TPI-PRO/DVI can remain idle before activating sleep
mode. When the device goes into sleep mode, the LCD (on connected touch panels) is
powered-down.
Press the UP/DN buttons to increase/decrease the timeout value.
• Range = 0 - 240 minutes (0 = Display Timeout disabled)
• Default = 5 minutes
Note: You must exit the setup page in order for the "Display Timeout" & "Inactivity Page Flip
Time" settings to be saved to memory.
Sets the length of time (in minutes) of inactivity allowed before the TPI-PRO/DVI will
automatically flip to a pre-selected panel page (on connected touch panels). In this case, the
LCD does not power-down.
Press the UP/DN buttons to increase/decrease the timeout value.
• Range = 0 - 240 minutes (0 = Inactivity Page Flip Timeout disabled)
• Default = 5 minutes
• The touch panel page used for the Inactivity page flip is shown within a small Inactivity
Page field.
Note: You must exit the setup page in order for the "Display Timeout" & "Inactivity Page Flip
Time" settings to be saved to memory.
TPI-PRO/DVI Configuration Pages
59