Upgrading Firmware
Prepare the NetLinx Master for Ethernet Communication
1.
Obtain the IP Address of the NetLinx Master to which the TPI-PRO/DVI is connected.
2.
In NetLinx Studio, open the Master Communication Settings dialog (FIG. 82).
FIG. 82
NetLinx Studio - Master Communication Settings dialog
3.
Click Communications Settings to open the Communications Settings dialog (FIG. 83).
FIG. 83
NetLinx Studio - Communication Settings dialog
4.
Under Platform Selection, select NetLinx Master.
5.
Click on Authentication Required if the Master is secured, then enter a valid Username and Password.
6.
Under Transport Connection Option, select TCP/IP.
7.
Click Edit Settings to open the TCP/IP Settings dialog (FIG. 84).
168
In NetLinx Studio's Online (device) Tree, select the target NetLinx Master.
Note the Master's IP address and Gateway information.
TPI-PRO/DVI (Total Presentation Interface)