Terminal/Telnet Commands - AMX TPI-PRO-2 Operation/Reference Manual

Terminal/Telnet Commands

Overview
The following telnet/terminal commands are supported by the TPI-PRO/DVI, via the SERIAL (DB-9) port on
the front panel (see the SERIAL Port section on page 17).
Terminal/Telnet Commands
disk free
get dns
get ip
get config
mem
msg on|off
ping [address]
reboot
set dns
set ip
show log <start>
show mem
setup
get cache enable
get cache expire
get cache size
get cache
toggle cache enable
cache purge [mask]
set cache expire
set cache size
show connection log
show connection stats Show the connection stats for the panel.
get connection
get device
set device
set connection
version
temp info
input stats [1-4]
Terminal Only
echo on|off
TPI-PRO/DVI (Total Presentation Interface)
Show the amount of free space on the disk.
Show the DNS configuration of a device.
Show the IP configuration.
Show the current configuration.
Shows size of the largest block of available memory.
Enables/Disables extended diagnostic messages.
Pings an address. Address may be an IP or URL.
Reboots the device.
Setup the DNS configuration of a device.
Setup the IP configuration of a device.
Display the message log.
• <start> specifies message to begin the display.
• 'all' will display all messages
Display the memory usage for all memory types (requires msg on).
Display setup page on panel.
Get the state of the image cache flash backup
Get current expiration time for image cache entries
Get flash cache maximum size
Display all image cache parameters.
Toggle the state of the image cache flash backup
Purge image cache (bit 0=NV, bit 1=RAM)
Set expiration duration for image cache entries
Set flash cache maximum size
Show the connection logs for the panel.
Show the master settings.
Show the device number.
Setup the device number.
Setup the master settings.
Display the version(s) of the units components.
Display the temperature sensor data.
Display the video input statistics.
Enables/Disables echo of typed characters.
Terminal/Telnet Commands
165