AMX TPI-PRO-2 Operation/Reference Manual page 207

"rb" indicates VESA reduced blinking timings.
Additional output modes for TPI-PRO-DVI are:
Standard output modes for TPI-PRO-DVI only
Resolution
720x480@60
720x576@50
1280x720@50
1280x720@60
1920x1080@50
1920x1080@60
Extended CEA refresh rates are recommended for DVI outputs, and may not work
reliably with VGA outputs.



If you are downgrading the firmware on the TPI-PRO/DVI to version 2.5.10 or earlier
and you are using the 1280x800@60Hz resolution, change the panel page resolution
to a different setting since this resolution does not exist in earlier firmware versions.
Failure to do so results in your panel resolution being reset.
TPI-PRO/DVI (Total Presentation Interface)
Standard Command
CEA861 'ORES-720x480@60 CEA'
CEA861 'ORES-720x576@50 CEA'
CEA861 'ORES-1280x720@50 CEA'
CEA861 'ORES-1280x720@60 CEA'
CEA861 'ORES-1920x1080@50 CEA'
CEA861 'ORES-1920x1080@60 CEA'
Additional output modes can be sent, and if a standard does not match, then VESA CVT timings
will be calculated for the output timings. The CVT timings will be standard blanking if the pixel
clock is within allowable limits, or will be CVT reduced blanking (rb) timings.
The TPI-PRO-DVI does not provide Component (YPbPr) or Interlaced outputs.
See the ORES command on page 132.
Supported Input and Output Modes
201