FIG. 84
NetLinx Studio - TCP/IP Settings dialog
8.
Add the Master's IP Address to the List of Addresses:
FIG. 85
NetLinx Studio - New TCP/IP Setting dialog
FIG. 86
NetLinx Studio - Edit TCP/IP Properties dialog
9.
Click OK to close all open dialogs and save your settings.
10.
When the Master Communication Settings dialog is closed after changing settings, NetLinx Studio
prompts you with the following warning dialog (FIG. 87):
TPI-PRO/DVI (Total Presentation Interface)
Click New to add the Master's IP Address, via the New TCP/IP Setting dialog (FIG. 85).
Alternatively, select an IP address from the List of Addresses and click Edit to alter it's properties
via the Edit TCP/IP Properties dialog (FIG. 86).
Upgrading Firmware
169