Torque Stop Adjustment; Engine Isolator Limiter Setting - Polaris IQ 2007 Service Manual

Maintenance

Torque Stop Adjustment

GAP
Set torque stop bumper gap to specification after aligning drive
and driven clutches.
Torque Stop Bumper-to-Engine Gap
.010 - .030 (.25 - .75mm)
After setting gap, torque jam nut to specification.
Torque Stop Jam Nut: 15-17 ft-lb. (21-24 Nm)
NOTE: Where applicable, when installing a new
torque stop, position bumper so the tip is just
touching crankcase.
3.6
= In. / mm.
= T

Engine Isolator Limiter Setting

Some models use an engine mount strap isolator. The isolator is
located on left-front corner of the bulkhead. The isolator should
not make contact with the engine strap.
If the isolator requires adjustment or replacement, hold the
isolator so it is against the bracket, then torque the nut to
specification.
NOTE: Do not adjust this engine isolator limiter as a
torque stop or damage may occur. The approximate
distance from the face of the isolator to the face of
the engine strap is 0.107" (2.72mm).
NUT
ISOLATOR
ISOLATOR AGAINST BRACKET
Jam Nut: 15-17 ft-lb. (21-24 Nm)
BRACKET
= T