Polaris IQ 2007 Service Manual page 229

Steering and Suspensions
IQ Switchback 144 Front / Rear Torque Arms
C
UPPER SHAFT
LIMITER STRAPS
A = 12 Ft.Lb. (16 Nm)
B = 19 Ft.Lb. (26 Nm)
C = 45 Ft.Lb. (61 Nm)
D = 35 Ft.Lb. (47 Nm)
E = 25 Ft.Lb. (34 Nm)
Assembly Notes
• Never re-use Nylock nuts. Always replace with new
parts.
• All pivots must rotate freely after tightening fasteners.
8.26
B
B
B
SHOCK ASSEMBLY
= T
FRONT TORQUE ARM
LOWER SHAFT
SHOCK ASSEMBLY
REAR TORQUE ARM
C SHAFT
E
D
D
ADJUSTER
SHOCK ROD
• Apply Polaris Premium All Season Grease to all grease
zerks as outlined in the periodic maintenance table.
The fasteners securing the rear suspension to the
tunnel are pre-coated with a locking agent when new.
Never re-use these fasteners when removed. Always
use new pre-coated fasteners when mounting the
suspension to the tunnel.
REAR PIVOT (SCISSOR)
B
SHAFT
CARRIER WHEEL
SLEEVE
SPACER / SET SCREW
SPRING
CAUTION