Electronic Speedometer Drive Train Assembly - Polaris IQ 2007 Service Manual

Final Drive and Brakes
Electronic Speedometer Drive Train
Assembly
WASHERS
A
SPACER
DRIVEN CLUTCH
SPEEDOMETER FLANGE
D
SPEEDOMETER SENSOR
A = Driven Clutch Fastener = 17 Ft.Lbs. (23 Nm)
B = Jackshaft Flange Nuts = 17 Ft.Lbs. (23 Nm)
C = Speedometer Housing Nuts = 17 Ft.Lbs. (23 Nm)
D = Driveshaft Housing Nuts = 17 Ft.Lbs. (23 Nm)
E = Chaincase Mounting Nuts = 28 Ft.Lbs. (38 Nm)
F = Speedometer Sensor Screw = 5 Ft.Lbs. (7 Nm)
G = Speedometer Gear Screw = 15 Ft.Lbs. (11 Nm)
CAUTION
Do not over-torque the chaincase mounting nuts.
6.8
BELT
FLANGE
WASHERS
C
G
F
DRIVESHAFT
= T
B
JACKSHAFT
FLANGE
SNAP RING
CHAINCASE
NOTE: Set driven clutch offset following procedure
in the PVT System Chapter.
Lubricate components as outlined in the Periodic
Maintenance Table.
Tighten chaincase mounting nuts using a criss-
cross pattern.
Install jackshaft seal sleeve with beveled edge
towards brake disc, then install o-ring inside sleeve.
BRAKE DISC
SEAL SLEEVE
O RING
E
E