Seat Cover Replacement; Decals; Decal Removal - Polaris IQ 2007 Service Manual

Chassis

Seat Cover Replacement

1. Remove seat.
2. Remove the old covering by removing the staples that hold
it on the base.
3. Drape the new cover over the seat foam.
4. Turn the assembly over and begin upholstering by lining up
the seat cover vinyl side flaps with the indented square
location indicators located on the plastic seat base.
WARNING
Apply staples in the stapling channel only. If you apply
staples outside the channel, you will damage the fuel
tank reservoir in the seat base. If this happens you will
have to replace the entire seat assembly.
5. Using a staple gun, tack each side of the vinyl cover in place
using two staples (1). If cover has a "POLARIS" emblem
carefully align emblem with the bottom edge of the seat.
This will help ensure that the cover is positioned properly.
6. Align the two sewn seams located at the rear of the seat
cover with the two back corners of the seat base.
7. Pull the vinyl tight and tack the seat cover to the plastic seat
base in each corner. Use two or three staples per corner.
8. Now that the cover is positioned, and tacked to the plastic
seat base in for places, turn the assembly over an inspect it.
If the seat cover seems to fit correctly and everything looks
straight, continue.
9. Staple the remainder of the unattached seat cover to the
plastic seat base. Always staple between two existing
staples and follow this procedure until the seat cover is
completely stapled to the seat base see the staple sequence
above.
10. Turn the seat cushion assembly over and inspect for
wrinkles or imperfections. If imperfections are visible,
remove the staples in the affected area and staple correctly.
11. Trim excess vinyl from the bottom around the back of the
seat area only after a satisfactory fit is obtained.
10.10

DECALS

Decal Removal

Before beginning, read these instructions and check to be sure
all parts and tools are accounted for.
Cleaning Solution
Cheese Cloth
3Mt Cleaner
Use the following items:
• Squeegee
• Cheese Cloth or a non abrasive cloth
• Paper Shop Towels
• Hair Drier or Heat Gun
• Wallpaper seam roller or similar roller
• 3Mt citrus based clear (3Mt PN 62-4615-430-5)
available at most auto parts stores
• Cleaning solution (99% water 1% mild dish washing
detergent)
• ScotchR 233 Performance masking tape
Perform the decal removal procedures carefully! If care is not
taken, the possibility exists that paint could peel from the hood.
Follow each step thoroughly and completely to avoid hood
damage! Polaris is not responsible for any hood or paint
damage resulting from this decal replacement procedure.
CAUTION
U
SE SAFETY GLASSES AND RUBBER GLOVES WHEN PER
FORMING THIS PROCEDURE
Squeegee
Hair Dryer
.
-