Polaris IQ 2007 Service Manual page 223

Steering and Suspensions
M-10 128 Front / Rear Torque Arms
C
UPPER SHAFT
LIMITER STRAP
A = 12 Ft.Lb. (16 Nm)
B = 35 Ft.Lb. (47 Nm)
C = 70 Ft.Lb. (94 Nm)
Assembly Notes
• Never re-use Nylock nuts. Always replace with new
parts.
• All pivots must rotate freely after tightening fasteners.
8.20
B
A
A
CARRIER WHEEL BRACKET
C
UPPER SHAFT
REAR TORQUE ARM
= T
SHOCK ASSEMBLY
FRONT TORQUE ARM
FTA SHAFT
CARRIER WHEEL
B
B
• Apply Polaris Premium All Season Grease to all grease
zerks as outlined in the periodic maintenance table.
The fasteners securing the rear suspension to the
tunnel are pre-coated with a locking agent when new.
Never re-use these fasteners when removed. Always
use new pre-coated fasteners when mounting the
suspension to the tunnel.
SHOCK ASSEMBLY
LOWER SHAFT
CAUTION