DRIVE TRAIN
Speedometer Cable Type Drive Train
Assembly
A
A = Driven Clutch Fastener = 17 Ft.Lbs. (23 Nm)
B = Jackshaft Flange Nuts = 17 Ft.Lbs. (23 Nm)
C = Speedometer Housing Nuts = 17 Ft.Lbs. (23 Nm)
D = Driveshaft Housing Nuts = 17 Ft.Lbs. (23 Nm)
E = Chaincase Mounting Nuts = 28 Ft.Lbs. (38 Nm)
CAUTION
Do not over-torque the chaincase mounting nuts.
D
C
= T
Final Drive and Brakes
B
E
NOTE: Set driven clutch offset following procedure
in the PVT System Chapter.
Lubricate components as outlined in the Periodic
Maintenance Table.
Tighten chaincase mounting nuts using a criss-
cross pattern.
Install jackshaft seal sleeve with beveled edge
towards brake disc, then install o ring inside sleeve.
6
E
6.7