Polaris IQ 2007 Service Manual page 156

10. Using a 10mm open end wrench tighten the lock nut while
holding the other nut with a 10mm open end wrench. Make
sure that the oil cable angle is tilted slightly toward the
engine.
11. Thread on the adjuster nut and adjust the oil pump and
adjust the oil pump.
12. Carefully place the engine into the engine compartment and
line up the engine mount studs with the engine straps on the
engine.
NOTE: Make sure that all hoses, lines and wires are
not pinched or interfere with installation.
13. Route the oil supply line from the engine through the hose
guide.
14. Install the oil bottle and hook up the supply line. Open and
slide the hose clamp onto the hose and oil bottle fittings.
Engine and Cooling Systems
15. Secure the oil bottle to the chassis by installing the two torx
fasteners located at the top of the bottle.
16. Connect the oil sender (Yellow and Purple wires) to the
chassis connection (Purple and Brown wires).
17. Connect all the coolant hoses.
18. Place panduit straps in the locations shown.
19. If applicable, place the coolant hose from the throttle bodies
to the coolant bottle.
20. Secure the hose clamp over all coolant hose and fittings.
5
5.37