Engine and Cooling Systems
gasket.
8.
To remove the oil pump / cover, remove the two fasteners
then pull the pump / cover out of the crankcase bore.
Discard the gasket.
9.
The cross shaft can be extracted from the water pump side
of the crankcase.
600 / 700 / 800 CFI Oil Hose Routing
5.32
10. Assembly is the reverse of disassembly. Always use new
o-rings, seals and gaskets during assembly.
11. Install a new seal onto the shaft from the water pump side.
12. To install a new water pump seal, use the seal installation
tool, PN 2872010. Verify the seal lips are facing the cross
shaft gear.
TEE FITTING