Throttle Lever Free-Play - Cfi Models; Choke Adjustment - Polaris IQ 2007 Service Manual

4. Once you achieve the proper free play of 0.010
(.25-.80mm), tighten the lock nuts.
5. Verify the oil pump index marks are within specification.
6. Check the idle RPM and verify it is within the specified
range.
NOTE: If the idle speed screw is adjusted inward
and the cable sleeve is not adjusted to take up the
throttle lever clearance, the engine may misfire or
kill upon initial throttle opening.

Throttle Lever Free-Play - CFI Models

CAUTION
When adjusting throttle lever free-play, always verify the
engine RPM does not rise with bars in the full low and full up-
right Rider Select positions (if applicable) and while turning
the handlebars to the full left and full right positions.
= In. / mm.
Throttle Lever Free Play: 0.010
The inline adjuster should only be used to set free play and to
remove cable slack that occurs if the cable has stretched over
time.
ADJUSTER
LOCK NUT
NOTE: Never use the in-line adjuster to adjust
engine idle speed and never adjust the cable so that
the throttle plate cam on the throttle body no longer
rests against the idle air gap screw.
Turning the in-line adjuster inwards (clockwise) will increase
throttle lever free-play.
Turning the in-line adjuster outwards (counter-clockwise) will
decrease throttle lever free-play.
" "
-0.030
" "
-0.030 (.25-.8mm)
After setting the throttle lever free play, always verify the oil
pump adjustment is set correctly.

Choke Adjustment

1. Flip the choke toggle to the "OFF" position.
2. Loosen locknuts (1) on the carburetor.
3. Turn sleeve adjusting nut (2) counter-clockwise until the
choke toggle shows no free play when pulled, then rotate
it clockwise until there is between 1/8 - 1/4in (3.2-.6.4mm)
free play (3).
NOTE: Verify the cable does not lift the plungers
when checking the free play.
1/8 - 1/4in. (3.2-6.4mm)
4. Tighten adjustment locknut (2).
Maintenance
3
2
1
3
3.17