Polaris IQ 2007 Service Manual page 96

Hide thumbs Also See for IQ 2007:
Table of Contents

Advertisement

T
C
ROUBLE
ODE
MAG Part Load Injector Circuit Open
MAG Full Load Injector Circuit Open
PTO Part Load Injector Circuit Open
PTO Full Load Injector Circuit Open
Fuel Injector Voltage Too High
Fuel Injector Voltage Too Low
MAG Ignition Coil Circuit Malfunction
PTO Ignition Coil Circuit Malfunction
5 Tooth CPS Signal Missing
5 Tooth CPS Signal Intermittent
5 VDC Sensor Supply Voltage Low
Chassis Voltage High
Chassis Voltage Low
Ignition Voltage Circuit Malfunction
Chassis Relay Coil Open Circuit
CFI Diagnostic Trouble Codes
MFD B
LINK
P-C
ODE
C
ODE
P0261
P1261
P0264
P1264
7
P2148
P2147
P0351
9
P0352
P0335
10
P0336
P0643
Steady LED
P0563
P0562
P0350
P1611
Fuel Systems
D
ESCRIPTION
OPEN circuit or short to ground. Can be caused by
faulty wiring, injector, stator or ECU.
Engine is running, but the injector voltage is above
the acceptable limit. Can be caused by faulty wiring,
ECU or stator.
Engine is running, but the injector voltage is below
the acceptable limit. Can be caused by faulty wiring,
ECU or stator.
Failure within the primary circuit. Can be caused by
faulty wiring, ignition coil, or ECU.
Engine is running, but there is no signal from the 5
tooth CPS. Can be caused by a faulty stator, wiring or
ECU.
Engine is running, but the pulses from the 5 tooth
CPS are incorrect. Can be caused by a faulty stator,
wiring harness or there is no 2 tooth CPS signal. If
there is no 2 tooth CPS signal, the engine will not run,
but the P0336 code will be set because the ECU
receives extra 5 tooth signals without any 2 tooth
signals.
Sensor supply voltage is below an acceptable limit.
Can be caused by faulty wiring or ECU.
System voltage is too high. Can be caused by faulty
wiring or regulator / rectifier.
System voltage is too low. Can be caused by a faulty
wiring or regulator rectifier.
Engine is running but a problem is found with the
ignition coil power circuit. Can be caused by faulty
wiring or ECU.
The chassis relay control circuit is open. Can be
caused by faulty wiring or a faulty relay.
4
4.17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Iq 2008

Table of Contents