Maintenance
STEERING / SUSPENSION
MAINTENANCE
Handlebars
Periodically inspect the torque of the handlebar clamp fasteners.
STEERING POST
1.
To adjust the handlebar angle, remove the handlebar cover
to expose the clamp.
2.
Loosen the four clamp fasteners. Slightly pry the upper
clamp up with a flat blade screwdriver.
3.
Adjust handlebars to desired position. Verify the wiring
harness, brake hose, and throttle cable do not kink.
4.
Secure the front clamp fasteners first to specification.
Finish by securing the two rear clamp fasteners to the same
torque setting.
Handlebar Clamp Fastener Torque
16 Ft.Lbs. (21 Nm)
5.
If equipped, reinstall the handlebar cover.
3.18
CLAMPS
= T
Rider Select Steering U-Joint
APPLY FOGGING OIL
The rider select steering U-joint should be lubricated with
Polaris fogging oil (PN 2870791).