Table of Contents
Advertisement
CARBURETOR SERVICE
Disassembly
CAUTION
W
EAR EYE PROTECTION WHEN USING COMPRESSED AIR OR
WHEN USING CLEANING SOLVENTS
SYSTEM WARNINGS LOCATED AT THE BEGINNING OF THIS
CHAPTER BEFORE PROCEEDING
1.
Remove the carburetor from the engine before
disassembling. Clean the outside of the carburetor
thoroughly with solvent. Do not use compressed air to dry
at this time.
2.
Remove all top cap screws (1), top cap (2) and gasket (3).
2
1
3.
Locate the arm screw (4) and loosen it just enough to move
the arm (5) out of the way so that you can remove the needle
(6) e-clip and the plastic washer from the throttle slide.
6
. R
EVIEW ALL FUEL
.
3
4
5
NOTE: Keep track of the plastic washer (9), and
place it so it is on the top of the throttle valve when
installing the needle and e-ring back into the
carburetor.
4.
Inspect the needle (7), e-clip (8), and plastic washer (9) for
wear.
8
9
5.
Remove the four screws (10) on the funnel face.
6.
Turn throttle shaft so the throttle slide (11) slides open all
the way.
7.
With slide fully open, pull funnel (12) out from the bottom
first. Inspect the gasket (13).
8.
Check for wear on the faces of the slides.
13
Fuel Systems
7
10
11
12
4.11
4
Advertisement
Chapters
Table of Contents
