Unloading Filament (Printer In Standby Mode) - Cubicon Single Operation Manual

The filament is coiled around the spool. Because of its shape, the
filament that is unwound from the spool will have a gentle curved shape.
When this curved shape is inserted into the extruder, it may not be
smoothly pushed into the entry of the nozzle rod.
It will be easier if the filament is positioned so that it is curved in the
clockwise from the front.

6.6.2. Unloading Filament (Printer in Standby Mode)

① Pull the Teflon tube out of the filament entry of the
extruder.
② (While the power is on)
Select {Prepare > Unload Filament} from the menu.
You can click {Temp} and set or change the target
temperature to unload. Set the temperature to suit the
filament in use.
The figure on the right hand side shows the heating
nozzle temperature changed to 240C.
"Wait..." blinks until the extruder nozzle temperature
reaches the target level. Wait until the nozzle
temperature reaches the target value.
When the extruder nozzle temperature reaches the
target value, the "Wait..." message disappears, and
{Unload Start} is displayed.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
(150616,En)
25 / 44