Replacing Filament (Loading/Unloading); Loading Filament (Printer In Standby Mode) - Cubicon Single Operation Manual

6.6. Replacing Filament (Loading/Unloading)

Filament must be inserted into the extruder to push the melted filament, which is the printing material,
through the nozzles, and the filament must be pulled out of the extruder to replace a filament with
another.
Loading is the process of inserting the filament into the extruder when there is no filament inside the
extruder so that the filament can be melted and pushed out of the nozzles for printing, while unloading
is taking the filament out of the extruder.
To replace the currently used filament with another filament, the current filament must be
unloaded and the new filament must be loaded.

6.6.1. Loading Filament (Printer in Standby Mode)

① Pull out the filament to the edge of the Teflon tube,
"5.2.2. Mounting of Filament
referring to
② (While the power is on)
Select {Prepare > Load Filament} from the menu.
You can click {Temp} and set or change the target
temperature to load. Set the temperature to suit the
filament in use.
The figure on the right shows the heating nozzle
temperature changed to 240C.
The "Wait..." message will blink until the extruder
nozzle temperature reaches the target level.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Spool".
(150616,En)
23 / 44