Mounting Of Filament Spool - Cubicon Single Operation Manual

5.2.2. Mounting of Filament Spool

① Prepare the filament spool to be used.
Cut off the filament sticking out of the
filament fixing hole at the center of the
spool and remove the fixing tape of the
filament.
② Push the spool door handle on the printer body in
the direction of the arrow shown in the picture to open
the door of the spool carrier.
④ Open the top door and push the filament all the way
into the printer body so that the filament is out of the
Teflon tube.
Be careful not to bend, cut or twist the filament tube.
This may prevent the filament from being supplied
properly.
* The filament spool should be installed in the correct direction.
Mount the spool so the company logo or product sticker is shown from outside.
The filament spool is designed to supply the filament while rotating counterclockwise. If the direction is
not set correctly, there can be a problem with filament supply, which can cause the printer to malfunction.
Use the printer only after confirming that the filament is correctly mounted.
* An obstacle between the filament rod and spool interfering with the spool's rotation will create a problem
with filament supply and cause the printer to malfunction.
Remove any obstacle to rotation when inserting the spool into the spool rod.
included in the spool package must be removed from the spool.
* The Teflon tube is the moving path of the filament from the spool to the extruder. Since its length is
optimized specifically for the printer, pulling the tube with excessive force will bend or twist the tube inside
the printer and interfere with filament movement, causing a malfunction. Do not bend, cut or pull the Teflon
tube with excessive force.
* When detaching the rest of filament spool from the spool carrier, pay attention to secure it and unwind it
during the storage. If the filament is unwound, it causes the twist of filament.
* Keep the rest of the filament in plastic bags not to be exposed to the external environment such as humidity
and dirt and use the filaments as fast as possible after opening.
If the filament is exposed to the external environment for a while, the printing quality may get worse or even
worse, it stops extruding from the Extruder.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Cutting
③ Slowly unwind the filament from the filament spool
and insert the filament into the filament insertion hole.
Be careful of the spool rotation/insertion direction.
⑤ Insert the filament spool into the filament rod and
push the handle until you hear a clicking sound. Close
the spool door and fix the spool.
Be careful of the spool rotation/insertion direction.
In particular, the silica gel
(150616,En)
1
2
Spool
Rotation
15 / 44