Cubicon Single Operation Manual page 24

③ When the extruder nozzle temperature reaches the
target value, the "Wait..." message disappears, and the
{Load Start} menu is displayed.
When you select {Load Start}, the extruder motor to
move the filament is operated, and the "Insert Filament"
message is displayed.
If the edge of the filament in the Teflon tube is bent
or pressed, cut off the part with scissors.
filament and push it until you can feel it is pulled to the
filament entry at the top of the extruder. If you insert the
filament by around 7cm, the filament is notched to the
gear and automatically pushed.
You may feel a little tightness when the filament is
inserted into the entry. This is due to the filament
supply detection switch. Push it with more force.
When the filament is pushed automatically, wait for a
while until the melted filament sticks out of the nozzle at
the bottom. Click the [ENTER] button to stop loading
after around 30cm of filament slides down.
④ Insert the edge of the Teflon tube into the filament
entry. Remove the filament sticking out of the nozzle
with tweezers or another appropriate means.
* Make sure that no part of the body contacts the nozzle area, as both the nozzle and the filament are hot
when the extruder nozzle temperature is raised.
* The filament may be stuck at the entry of the nozzle rod when it is pushed into the nozzle rod of the
detachable extruder part. (A cracking sound may be produced.) In that case, press the filament handle and
pull out the filament. Cut off the edge with scissors and insert it into the filament entry to attempt loading
again.
* If you manually handle the filament with the handle, be careful not to pull out the filament with excessive
force, as it may damage the internal sensor or nozzle rod.
* If there is no filament inside of Extruder, Loading menu will be deactivated. In this case insert the filament
into the extruder slot, and then Loading menu will be activated
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Hold the
(150616,En)
24 / 44