Turning On Printer - Cubicon Single Operation Manual

5.2.3. Turning on Printer

Confirm that the packaging materials inside the printer have been completely removed, that there is no
damage, and that the spool mounting/rotation direction/rotation conditions are all normal before turning on
the printer.
Do not turn off the power while the heated bed or extruder is heated up. Because the cooling fan is not
spinning the print may be broken down or fire may occur by high temperatures
① Turn off (O position) the power switch on the rear of
the printer body.
Please double-check the following before you turn on the printer.
1) Eliminate any bending or twisting of the power cable; check the connection of the power cable to the socket.
2) Confirm the mounting of the filament spool (with attention given to the spool rotation direction).
3) Check the proper movement of the Teflon tube.
Confirm that the Teflon tube is in a slightly inclined position when the Teflon tube is inserted into the filament
insertion hole of the extruder and the extruder is pushed all the way to the left.
4) Check the condition of the extruder-driven cable.
Confirm that there is no damage to the cable and that the extruder-driven cable is in appropriate condition.
5) Confirm that the detachable extruder is properly mounted and fastened.
Ensure it is fastened, as the fastening screws may be loosened during transport.
6) Confirm that the heating bed is mounted in the correct position.
Ensure it is fastened, as the heating bed may have been moved during transport.
③ Turn on (l position) the power switch on the rear of
the printer body.
* When you disconnect the power or USB cable, do not grip the cable part, but grip the connector and pull
it out.
* The USB cable is to connect to a PC to print from the PC or update the printer's firmware. If the printer is
not connected to a PC, the USB cable does not need to be connected.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
② Push the power cable into the power input
connector on the printer body, arrange the power cable
so that it is not twisted, and push the power cable into
the socket.
④ Check the LCD display.
Activation
Indication
Initial
Screen
* The figures on the screen will change according to the
surrounding temperature.
* The displayed statement may be different text with
firmware version.
(150616,En)
16 / 44