Functional Menu During Printer Standby - Cubicon Single Operation Manual

6.3. Functional Menu during Printer Standby

"6.2. LCD Display of
If Status" is shown on the LCD screen of Cubicon Single, press the [ENTER]
button to display the functional menu. You can access each item of the function menu by turning and
pushing the [ENTER] button or pushing the [BACK] button. Press the [HOME] button to return to the
status display window.
The following menu is available when the printer is in standby mode. A different menu is displayed
when the printer is in printing mode.
> SD Card
> Prepare
> Preheat
> ABS / PLA / U01 / U02
> Autotilt Align
> Load Filament
> Temp
> Load Start
> Unload Filament
> Temp
> Unload Start
> Temperature
> Cooldown
> Extruder
> Bed
> Chamber
> Fan speed
> Motions
> Disable stepper
> Bed Up
> Bed Down
> Extr. Move
> Home
> Parking
> Configuration
> Preheat Temp
> ABS / PLA / U01 / U02
Preheat Temp
> Extruder
> Bed
> Chamber
> Autotilt
> Bed Offset
> Always Autotilt
> Filament Check
> Filter Fan
> Baudrate
> 250000 / 115200
> Store to EEPROM
> Initialize EEPROM
> Information
Note) The actual menu structure may differ depending on the firmware version.
This document is based on Firmware Ver. 2.0.0, Cubicreator v2.0.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Selects the output file in the inserted SD memory.
Preparation for printing
The heating bed and extruder nozzle are preheated to the set
temperature.
They are preheated to the preset temperature.
This tests Auto tilt.
This inserts a new filament into the extruder.
This sets the extruder nozzle temperature to use a new filament.
This inserts the filament into the filament entry when the target nozzle
temperature is reached.
This removes the filament in the extruder.
This sets the extruder nozzle temperature to remove the filament.
This pulls out the filament when the target nozzle temperature is reached.
Printer operation temperature control
Temperature initialization (Heating is stopped to lower the temperature)
Extruder nozzle temperature setting
Heating bed temperature setting
Printer inside maximum temperature setting
Print fan speed setting
Printer movement control in standby mode
This disables the motor to enable manual control.
The heating bed is lifted.
The heating bed is lowered.
The extruder motor is manually rotated (manual lifting or lowering of the
filament).
The X/Y (extruder) and Z (heating bed) are moved to the zero position.
They are moved to the position (rear center) during idle status.
Default setting
This sets the preheat temperature.
This sets the preheat temperature according to each condition.
Extruder nozzle preheat temperature setting
Heating bed preheat temperature setting
Printer inside maximum temperature setting
This adjusts Auto tilt.
Offset between heating bed and nozzle after Auto tilt
Option to always run Auto tilt before printing.
Option to use the filament supply detection function.
Filter fan operation setting.
This sets the communication speed when printing through USB
connection from PC.
Default 250000, Printing through PC connection(MAC OS) 115200
The changed settings are saved in EEPROM.
When reboot without saving the changed setting, it cannot apply the
changed setting value.
The settings are initialized.
This displays the equipment model name and firmware/hardware version.
(150616,En)
19 / 44