Cubicon Single Operation Manual page 9

Use of Diverse and Smart Materials
Many FFF type printers are exclusively for PLA. This is because despite being a superior material in
many respects, such as strength, reliability, ease of post-processing and coating, ABS creates some
difficult problems, such as the dusts generated when being melted, the difficulty of shaping and the
difficulty of managing the heating bed.
Cubicon Single has adopted convection ventilation, clean filter and Auto Leveling Plus functions to
support the use of both PLA and ABS. Cubicon's Smart Spool features an untangling prevention
function to reduce the possibility of printing failure. The filament with Smart Spool label is sufficiently
tested, so that you can use it with confidence.
Although only limited colors of ABS and PLA filament spools are currently available, new filament
colors and materials are being developed to satisfy various printing requirements of users.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
(150616,En)
9 / 44