Functional Menu During Printing - Cubicon Single Operation Manual

6.4. Functional Menu during Printing

A different functional menu is displayed when the [ENTER] button is pressed while the printer is
printing an object. To prevent problems related to user error, only the applicable menus such as print
suspension are displayed.
You can access each item in the function menus by turning and pushing the [ENTER] button or
pushing the [BACK] button. Press the [HOME] button to return to the status display window.
Refer to the following table for the description of each functional menu item.
> Temperature
> Extruder
> Bed
> Chamber
> Fan speed
> Pause Print
> Continue Print
> Load Filament
> Temp
> Load Start
> Unload Filament
> Temp
> Unload Start
> Stop Print
> Stop Print No/Yes
> Stop Print
> Stop Print No/Yes
> Configuration
> Filament Check
> Filter Fan
> Information
The actual menu structure may differ depending on the firmware version.
Note)
It may also be different if the printing is controlled by a PC over the USB connection.
This document is based on Firmware Ver. 2.0.0, Cubicreator v2.0.
* When the Pause or Stop function is selected during printing, there will be a slight time delay. This is due to
the process of printing data that are already in the buffer memory. Printing will be paused or stopped after a
brief delay.
* When the {Loading/Unloading} menu is selected, the function is executed in the sequence of "Step to
increase the nozzle temperature (Wait...)  Step to insert or pull out the filament (Insert Filament/Pull Out
Filament)  Step to complete the function (Press Enter to Loading/Unloading Stop)." Follow the text on the
LCD screen during the execution.
"Check Filament" may be displayed in some function menus if the filament is not detected in the extruder. In
that case, check the filament and execute the {Unloading/Loading} function to supply the filament in the
extruder, and then continue printing.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Printer operation temperature control
Extruder nozzle temperature setting
Heating bed temperature setting
Printer inside maximum temperature setting
Print fan speed setting
Printing is temporarily stopped.
Printing is continued.
A new filament is inserted into the extruder.
This sets the extruder nozzle temperature to use a new
filament.
This inserts the filament into the filament entry when the target
nozzle temperature is reached.
This removes the filament from the extruder.
This sets the extruder nozzle temperature to remove the
filament.
This pulls out the filament when the target nozzle temperature is
reached.
This completely stops printing after a job is paused.
Stop printing confirmation
Printing is completely stopped.
Stop printing confirmation
Basic setting
Option to use the filament supply detection function.
Filter fan operation setting
Displays the equipment model name and firmware/hardware
version.
(150616,En)
20 / 44