Cubicon Single Operation Manual page 22

Load/Unload Filament operates the extruder motor to move the filament after the extruder
nozzle temperature reaches the set temperature. Check the extruder temperature when you
load or unload the filament.
{Load/Unload
Filament}
{Motion} provides the X/Y/Z axis operation mostly for maintenance. When you use this
function, make sure that there is no object or body part in the intended destination.
The {Motion} function performs an abnormal printer function. It is recommended not to use the
function during normal time.
{Motions}
You can save the time for Auto tilt to turn off the mode of {Configuration>Auto tilt>Always
Autotilt}. However if repeating the printing while this function is off, it can cause the problem on
the print object without tilting.
Activation of 'Always Auto tilt' (Always Auto tilt: ON) is recommended if there is any
{Always
Autotilt}
special case.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
* The temperature setting range of Chamber is 30 ~ 55C. If less than 30C, it will be
shown as 0C meaning that the internal cooling fan is not operating.
* Cubicon Single cools the inside with the external air, please note if temperature of
chamber is set to 0C, the internal temperature will be increased because the cooling fan is
not working.
* The internal temperature cannot go down as setting temperature according to the
external air because the Cubicon single cools down the inside with the outside air.
* Load/Unload is generally used to replace the filament.
To replace a filament, it is recommended to preheat the extruder nozzle in advance by
setting the extruder temperature to the extruder nozzle temperature of the filament
already melted in the nozzle or that of the new filament, whichever value is higher.
* When you use the filament supply detection function, the printer may suggest only
"Load Filament" or "Unload Filament" in some cases. In that case, execute the task
requested by the printer.
When a filament is used up, the edge of the filament will remain inside the extruder.
Using the printer without removing the residual filament may cause an extruder
problem. Unload the filament using {Unloading} after a filament is used up to remove
the filament remaining inside the extruder.
* It should be noted that if there is a body part or object in the path of {Motions}, injury
or damage may result. In particular, the printed object should not be left inside the
printer after printing is completed, as it may be collided with during {Motions}.
* When executing {Ext. Move} while the detachable extruder part is mounted, the extruder
temperature should first be increased above the level required to melt the filament in use.
Otherwise, the filament may be fragmented or cut off, and in extreme cases the extruder
may malfunction.
If the power is newly turned on, Auto tilt will be fulfilled once for the first time although
Always Autotilt is deactivated as {Always Autotilt : OFF}.
Cubicon Single Operation Manual
(150616,En)
22 / 44