Supplying Filament After Filament Runs Out During Printing - Cubicon Single Operation Manual

When {Continue Print} is selected, the extruder unit moves to the printer home position, which is left
forward, pushes out some filament to maintain a clean discharge, and then moves to the print continuing
position.
You can easily remove the filament at the edge of the nozzle during loading.

7.4. Supplying Filament after Filament Runs Out during Printing

Cubicon Single can automatically recognize when filament is running out and is not being supplied to
the extruder during printing.
If the filament runs out during printing, the switch inside the extruder does not detect the filament, and
will automatically stop printing. The extruder then moves to the standby position, and waits for user
confirmation and follow-up.
The picture below shows the scenario in which filament runs out during printing.
Although the filament is not visible from outside, as shown in the picture on the left, the filament
fragment actually remains inside the extruder, as shown in the figure on the right.
If you insert a new filament without removing the filament fragments remaining in the extruder,
the new filament will not be pushed out of the nozzle and can cause a problem with the extruder.
For this reason, you must unload the existing filament.
When you unload, the filament remaining inside
the extruder will come out, as shown in the
picture on the right.
Pull (2) the filament up out of the extruder while
pressing the filament handle (1).
Insert (load) a new filament and continue printing.
For more details on loading and unloading, refer to
Filament during Printing".
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
No Filament
Cubicon Single Operation Manual
2
1
"6.6. Replacing
Filament" and
(150616,En)
Filament
Remaining in
Extruder
"7.3. Replacing
39 / 44