Installation; Unpacking - Cubicon Single Operation Manual

5. Installation

Be careful when unpacking and installing the product, as excessive force or ripping can damage the content.

5.1. Unpacking

① Place the package on a level floor.
③ Pull the product out of the vinyl bag.
(two persons recommended)
* Two or more people should lift the printer because of its weight and volume.
* As the printer may slide off if you lift it by the vinyl cover, open the vinyl cover and hold the printer body
when lifting it.
⑤ Open the front door and pull out all internal parts
and accessories to make sure that they are all there.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
② Open the box and remove the top cover.
④ Move the product to its installation location.
(two persons recommended)
⑥ Open the top door and pull out the extruder
package. Be careful not to bend the extruder-driven
cable or the Teflon tube.
Teflon tube.
(150616,En)
13 / 44