Cubicon Single Operation Manual page 43

Check the model and G-Code. If the model is improperly designed, there can be a problem with G-Code

creation. Modify the model and try again.
For some models or supports, the printed object can interfere with the support, causing printing problems.

This problem can be corrected by changing the slicing method (adjustment of the printed object, change
of direction, etc.).
Remove the foreign substances from inside the nozzle. Clean the nozzle, referring to

Detachable Extruder and
If the problem continues when there is no problem with the model, replace the nozzle or other parts. Use

the authorized service.
10) Printing is terminated due to failed auto leveling without completion.
Check whether the vibration in the environment affects the printer during auto leveling. Auto leveling can

fail if the vibration is transmitted to the printer.
The printer executes auto leveling of the bed before beginning printing. If the auto leveling fails for
whatever reason (after several automatic attempts), the message "Tiltalign Failed" is displayed and

printing is stopped. As the problem can be solved by rebooting the printer, turn off the printer, wait for
around 10 seconds, and turn on the printer again.
If the Functional Menu {Configuration > Auto tilt > Always Auto tilt} is off, set it on. If it is off, the bed tilting

is now working properly.
After removing the filament, and separating the detachable Extruder, check if there is any problem on up

and down motion of the detachable Extruder. If up/down motion of detachable Extruder has some trouble
due to contaminants may cause problems in the Auto Level.
After checking if there is overload of filament path including internal Extruder, if there is overload by

contaminants, remove the contaminants and re-operate the Auto Leveling.
If the problem continues, replace the heating bed or have the authorized personnel check the printer. Use

the authorized service.
11) Filament supply detection function does not work properly.

Check the diameter of supply filament is range of 1.6~1.9mm and use it.
In case of Flexible filament like TPU, the filament can be pressed to the supply detection sensor, so

deactivate the filament supply detection function. (Set off on the menu of Configuration-Filament Check).
The mechanism of supply detection sensor is worn when used for long. Please replace it through the

authorized service center.
12) Printing is stopped before completion.

Check the power supply.

Check the connection with the PC if the printer is connected to a PC.

If the problem continues, turn off the power and have it checked by authorized personnel.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Nozzle".
(150616,En)
"6.8.2. Cleaning of
43 / 44