Accessories Included With Package - Cubicon Single Operation Manual

4.3. Accessories included with Package

Tweezers (x1)
Used to remove foreign
substances, such as filament
residues.
Scrapper (x1)
Used to separate the molded part
or remove foreign substances from
the heating bed
Antistatic brush (x1)
Used to remove the pollutants
such as the filament residues.
Nozzle pin ф=1.5mm (x1)
Used to clean inside of the nozzle
when the output quality has
deteriorated due to a polluted
nozzle.
SD Memory (x1)
Stores the slice files(.hvs) of 3D
models for molding used by the
printer
* The filament spool and clean filter are not mounted in the printer, but are packaged separately.
* The type and specification of the accessories included in the part may be changed without notice to
enhance the product.
* Please use the Cubicon homepage or contact a distributor to purchase additional accessories.
Using an unauthorized filament or part may cause damage to the product. Any problem related to the use of
an unauthorized part will not be covered by the after-sales service. Always use accessories supplied by
Cubicon.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
Power cable (x1)
The power cable for the printer
USB cable Type-A/Type-B (x1)
Connected to a PC and used for
output printing.
Clean filter (x1)
Mounted in the clean filter case of
the main body.
Filament spool
Mounted in the spool carrier. A
filament spool is provided to PLA
or ABS with random color
Quick Start Guide / Operation
Manual
User
Manual
Included as a printout or a file in
the SD memory.
(150616,En)
12 / 44