Printer Parts And Accessories; External Printer Parts - Cubicon Single Operation Manual

4. Printer Parts and Accessories

The printer is packaged after a total test of output conditions.
This testing may leave traces of usage on the heating bed, nozzle, etc. Be assured that these are traces of
testing, and that there is no problem with the product.

4.1. External Printer Parts

2
3
4
5
[1] Top door
[2] Front door
[3] Inclinometer
[4] Bottom door
[5] Clean filter case
[6] SD memory insertion hole
[7] LCD and operating buttons
[8] Filament insertion hole
[9] Spool door
[10] Spool door handle
[11] Spool carrier
[12] USB input (Type-B)
[13] Power switch
[14] Power input
[15] Leveling foot
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
1
6
7
8
9
10
11
Used for maintenance such as the filament replacement (loading / unloading),
separation of detachable extruder, etc.
Used to pull out the molded part
Used to check levelness when the printer is installed
Used for cleaning the bottom, etc.
Used to mount the clean filter
Used to insert the SD memory
Used to operate the LCD screen and printer
Used to supply the filament (located at the inner top when the spool door is
opened)
The door is used to fix the filament spool
Used to lock the spool door (should be locked after the spool is mounted)
Area in which the filament spool is mounted
USB input terminal to connect to a PC
Main power switch for the printer
Terminal to connect the power source of the printer
Used to set the horizontal levelness of the printer (4 at the bottom)
12
15
(150616,En)
13
14
10 / 44