Printing; Printing For The First Time - Cubicon Single Operation Manual

7. Printing

This chapter describes several important scenarios of actual printing using the SD memory card after
the printer is installed.
(Refer to the Cubicreator Software Operation Manual for the details of printing using a USB connection
to a PC.)

7.1. Printing for the First Time

After the printer is installed, print a sample as shown below to check the condition of the printer.
Before turning on the printer, confirm that all packing materials inside the printer have been removed, the
cables and parts are not damaged, the bed and extruder are properly installed, and the spool
mounting/rotation direction/rotation condition are normal. If there is any problem, correct it first before
turning on the printer.
① Mount the filament spool in the spool carrier of the
printer and push the filament all the way to the entry of the
Teflon tube inside the printer.
③ Press the [ENTER] button to display the menu. {Check
Filament} generally flashes in the position of {SD Card},
since there is no filament in the extruder.
If the printer is turned on when there is no filament in the extruder (incl. right after installation) or the
filament is loaded while filament fragments remain in the extruder, this can cause an extruder problem.
The printer logic requires it to unload the filament if the power is turned on when there is no filament (no
filament detected by the filament supply detection switch). If you do not see the filament in the filament entry
of the extruder and the printer begins unloading, load the filament after waiting until unloading is completed.
If {Check Filament}, {Unload Filament} or {Load Filament} blink in the menu, select the blinking menu and
follow the instructions to prevent an extruder problem.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
② Turn [ON] the printer. Since the filament is not yet
mounted in the extruder, "No Filament" is displayed
on the LCD screen.
④ When you select {Check Filament}, {Load
Filament} / {Unload Filament} are displayed as
shown below, and {Unload Filament} blinks to
instruct the user to execute {Unload Filament}.
Unload the filament, referring to
Filament".
(150616,En)
"6.6.2. Unloading
34 / 44