Replacement Of Clean Filter - Cubicon Single Operation Manual

to form the printed object with clean filament. Remove any residues on the nozzle before printing,
as they can affect the printed object.
* When you clean the printer while the nozzle is heated, be careful with the hot nozzle.
* It should be noted that the nozzle can be damaged and the print quality deteriorated when you press the
nozzle hole with tweezers, etc.
* If you use acetone for cleaning the nozzle, be careful not to stain parts other than the metallic nozzle with
acetone. This may damage the product.
* When using the acetone, make sure there is sufficient ventilation and use it with caution. (Strictly follow the
safety rules stated on the acetone package.)

6.8.3. Replacement of Clean Filter

To filter the pollutants generated by the FFF type printer, Cubicon Single uses a clean filter organized
into three filter layers: Purafil catalyst, HEPA filter and deodorizing filter.
If the clean filter unit contains too many pollutants, it not only will degrade the filter's performance but
will also interfere with the operation of the filter fan, causing problems. If the pollution of the clean filter
is too severe, do not clean the filter but replace it.
Although the clean filter replacement interval differs according to the printing environment and user
printing habits, it is recommended to replace it every 6 months.
The clean filter should be installed in the correct direction in the case. If the direction is not correct, the
filter's performance will deteriorate, and it will cause a ventilation fan problem.
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
(150616,En)
33 / 44