Cubicon Single Operation Manual page 35

⑤ When unloading is completed, {Load Filament} blinks
because there is no filament inside the extruder.
Select {Load Filament} to insert the filament inside the
extruder.
If {Load Filament} is not selected, push the filaments into
the filament insertion hole of the Extruder.
⑥ Select {Temp} in {Load Filament} and turn the [ENTER]
button to set the temperature to 240C and heat the
When the extruder nozzle temperature reaches the target
temperature, the "Wait..." message will disappear and the
{Load Start} menu will be displayed.
When you select {Load Start}, the extruder motor
to move the filament is operated, and the "Insert
Filament" message is displayed.
Insert the filament into the filament entry of the
extruder. When you push it approximately 7cm into
the entry, it is notched and automatically pushed
down. Manually push it until it is notched.
When some amount of melted filament is pushed
out of the nozzle, press the [ENTER] button to stop
filament loading.
Do not worry if the color of the melted filament that
comes out of the nozzle during loading is different
from the loaded filament. It is filament that was used
during the test and left in the nozzle.
* It is recommended to set the nozzle temperature during the very first printing as the ABS temperature,
regardless of the type of loaded filament, if ABS or PLA is used. It is set to 240
test. During the test, the ABS load temperature is used to support both ABS and PLA filaments.
"6.5. Caution and Notes on Using the Functional
(Refer to
Filament".)
* If the type of filament used in previous printing is not clear, set the extruder nozzle temperature based on
the filament of higher temperature, and heat the nozzle.
* When replacing the filament, it is recommended to load the filament so that a sufficient amount of filament
is pushed out of the nozzle (1m or longer).
Copyright Reserved HyVISION System Inc.
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Cubicon Single Operation Manual
nozzle.
"7.2. Printing after Replacing
Menu" and
(150616,En)
o
C for the final print quality
35 / 44